2/3U 800W x 2 Short Industrial Redundant PSU 80+ Gold with Pmbus

PCICASE Model No: PIZ2080R-90
Manufacturer Model No: M1D2-5800V0V
UK Stock

Key Features

 

  • 2 x 800 watt 80+ Gold Power Modules for redundancy and energy efficency.
  • Short depth design allowing for better air circulation
  • Flexibility to install high wattage PSU into shorter chassis 

Diagram For Alarm Reset Button Installation Into 2U Chassis

 

Install Alarm Reset Button Internally

 

 

Install Alarm Reset Button From Rear

 

 
Dimensions
200x101.2x84(mm) 
7.87x3.98x3.31(inch)
 
Input Specification
 
VOLTAGE: 90~264 Vac FULL RANGE 
FREQUENCY: 47~63 Hz 
INPUT CURRENT:12A (RMS) FOR 115V / 6A (RMS) FOR 230V 
INRUSH CURRENT:15A MAX. FOR 115V / 30A MAX. FOR 230V
 
 
DC Output Specification
 
Output Voltage Output Current Min. Output Current Max. Regulation Load Regulation Line Output Ripple & Noise Max.[P-P]
+5V 0 36 ±5% ±1% 50mV
+12V 2 66 ±5% ±1% 120mV
+3.3V 0 31 ±5% ±1% 50mV
-12V 0 0.5 ±5% ±1% 120mV
+5VSB 0.1 3 ±5% ±1% 50mV
           
           
           
           
* +5V AND +3.3V Max. POWER:210W
* TOTAL POWER: 800W (MAX)
 
 
Features
  • TEMPERATURE RANGE:OPERATING 0℃~50℃, STORAGE -20℃~80℃
  • HOLD UP TIME:WHEN POWER SHUTDOWN DC OUTPUT 12V MUST BE MAINTAIN 10MSEC IN REGULATION LIMIT AT NORMAL INPUT VOLTAGE 
  • EFFICIENCY: THE MAXMUM POWER SUPPLY SYSTEM EFFICIENCY SHALL BE 85%, MEASURED AT NOMINAL INPUT VOLTAGE 115V OR 230V AND FULL LOADING.
  • LEAKAGE CURRENT: 3.5 MA. MAX. AT NOMINAL VOLTAGE 240VAC
  • REMOTE ON/OFF CONTROL 
  • POWER GOOD SIGNAL:ON DELAY 100mS TO 500mS,OFF DELAY 1Ms
  • OVER POWER PROTECTION: The power supply shall provide over power protection on the power supply latches all DC output into a shutdown state. Over power of this type shall cause no damage to power supply, after over load is removed and a power on/off cycle is initiated, the power supply will restart. Trigger point total power MIN. 105%, MAX. 150%.
  • OVER VOLTAGE PROTECTION: +5V → 5.7~6.5V, +3.3V → 3.7~4.1V, +12V → 12.8~13.9V
  • SHORT CIRCUIT PROTECTION: +5V, +3.3V, +12V, -12V, +5VSB
  • OVER CURRENT PROTECTION
  • SAFETY: TO MEET UL, CUL, TUV, CCC 
  • WARNING METHOD: AUDIO ALARM(BUZZER SOUND, RESETABLE), FALUT LED, TTL

 

*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.

 

PSU Datasheet PIZ2080R-90  Datasheet
 

 PIZ2080R-90 Datasheet.pdf

 

PSU Drawing PIZ2080R-90  Drawing
 

 PIZ2080R-90 Drawing.pdf

 

PSU UL Certificate PIZ2080R-90 UL Certificate
 

 PIZ2080R-90 UL Certificate.pdf

 

PSU TUV Certificate PIZ2080R-90 TUV Certificate
 

 PIZ2080R-90 TUV Certificate.pdf

 

PSU CB Test Certificate PIZ2080R-90 CB Test Certificate
 

 PIZ2080R-90 CB Test Certificate.pdf

 

Get in touch

Give us a call to find out more about our products

Inside the UK
0870 300 3388

Outside the UK
+44 1908 272770

Or send us an email
pcisales@pcicase.co.uk